Convert Low-Band Plectron to UHF Band (420-512 MHz) without a change in tones: Includes making all engineering updates, a new UHF antenna (whip), and a year parts and labor warrant on the entire radio. Narrow-band audio recovery modification included (if needed). If there is a tone change, please contact me for further information.
$195.00 parts and labor
Convert Low-Band Plectron to VHF High-Band (150-174 MHz) without a change in tones: Includes making all engineering updates, a new VHF antenna (whip), and a year parts and labor warrant on the entire radio. Narrow-band audio recovery modification included (if needed). If there is a tone change, please contact me for further information.
$95.00 parts and labor
Convert Pilot Light to LED (for very long life)
$6.00
Convert existing Alert Flasher to LED (for long life)
$16.00
ADDITIONAL TONES: A or B tones
$30.00
OODS: On/Off duty switch
$8.00
RSO: Remote switching option see information on reconditioned receiver page.
$50.00
Auxiliary Relay Assembly: When used with the RSO option the Auxiliary Relay Assembly (ARA) expands the switching capability of the RSO to allow switching of two 120 volt lights of up to 500 watts each or other electrical items of similar power ratings.
$78.00
Telescoping Antenna Includes BNC Antenna Jack.
$28.00
Alert Flasher: WallaceRadio alert flasher. Flashes an LED upon activation of receiver until reset by reset switch.
$25.00
Internal Audible Alarm: See information on reconditioned receiver page.
$30.00
Long A or B group call tone
$50.00
Channel Activity Light for Plectron Patrol (non-tone activated) receivers: Provides an LED light on the front of the receiver while the radio is receiving. Available in red, blue, green and amber. If you are monitoring multiple channels it allows you to see which one is talking by glancing at the colored light(s).
$25.00
CTCSS (PL) decoder
$72.00
DPL decoder
$96.00
Two tone codes without common tones
Contact me for pricing at plectron@frontier.com
NOTE: Labor to install the options above is covered if they are installed when the radio is being repaired. If just the option(s) are being installed add $42.00 for a complete check of the radio and installing engineering changes. This is not a per option fee. You can have multiple options installed for the one fee. For example you can have an additional tone and Alert Flasher installed at the same time and the total charge will be $42.00 labor plus $30.00 Tone and $25.00 alert flasher
Total: $97.00